Bovi-Bond Adhesive Cartridge 160mlX

Bovi-Bond Adhesive Cartridge 160mlX

Write a review

Note: HTML is not translated!
    Bad           Good

Free Shipping

Free Australia delivery for all orders over $149.00

  • Product Code: 221429
  • Reward Points: 8
Bovi-Bond urethane adhesive, from USA, is a proven system for attaching
blocks to the healthy claw of lame cows’ hooves. Bovi-Bond does not need
any special skill to mix and apply. The secret is in the double-barrel
160ml adhesive cartridge and the special dispensing gun. This system
ensures that the two parts of the adhesive mixture are kept separate
until they merge in the mixing tip. After treating the affected claw,
the healthy claw is trimmed to leave a clean, flat and dry surface.

Follow the instructions below for preparation of the cartridge for
loading into the dispensing gun.
Apply about 20ml (a 3mm-thick layer) to the clean hoof surface. Press
the block lightly onto the adhesive, and hold still for 30 seconds.
The block will wear off or break off naturally, by which time, if you
repaired it correctly, the affected claw should have made a recovery.
Bovi-Bond adhesive sets in approximately 30 seconds after application of
the block. It can be load-bearing after 2 or 3 minutes (or slightly
longer in cold weather).

After opening, the Bovi-Bond adhesive cartridge must be used within one

Bovi-Bond Cartridge Instructions
1. Remove safety cap.
2. Bang tip down vertically on a hard surface to impact the plastic
stopper. Do not remove yet.
3. Insert cartridge in dispensing gun.
4. When ready to use, remove impacted plastic stopper from tip of tube
and discard.
5. Squirt a small amount of adhesive to waste to remove any air bubbles
in tip.
6. Attach mixing tip and dispense glue onto block.
7. Remove mixing tip and attach supplied plastic (with green inserts)
stopper. NB. Green insert legs must align with flat sides of stopper.
8. Tube can then be safely stored until next use.

8 Blocks per 160ml Cartridge.
  • $85.95
  • Price in reward points: 860